Use and Care Manual

ManualsBrandsSimpson Strong-Tie ManualsTools & HardwareQuik Drive Combo System for Makita 2500 RPM Screwdriver Motor

Attachments: QDPRO200G2, QDPRO200SG2,QDPRO250G2, QDPRO300SG2,

QDPROLDHG2, QDPRORFG2, QDPRO300RFG2, QDPROPHG2, QDHSD60, QDHSD75

SAVE THESE INSTRUCTIONS

Pointed End First

Deeper

Set Driving Depth

Use With Or Without The

“Stand-up” Extension

DRIVING SCREWS

Be sure screwgun is in

FORWARD.

Start screwgun before

applying driving pressure.

Continue to apply pressure,

keeping bit engaged until

screw is fully driven and

clutch releases.

Keep screwgun running

between screws.

90˚

Correct Grip

QUICK START INSTRUCTIONS Complete instructions inside

800-999-5099 www.strongtie.com

QUIK DRIVE

PRO SYSTEMS

OPERATING INSTRUCTIONS

Summary of content (4 pages)

PAGE 1
QUIK DRIVE® PRO SYSTEMS OPERATING INSTRUCTIONS Attachments: QDPRO200G2, QDPRO200SG2,QDPRO250G2, QDPRO300SG2, QDPROLDHG2, QDPRORFG2, QDPRO300RFG2, QDPROPHG2, QDHSD60, QDHSD75 SAVE THESE INSTRUCTIONS QUICK START INSTRUCTIONS 1. Complete instructions inside 2. Pointed End First 3. Deeper Set Driving Depth DRIVING SCREWS Be sure screwgun is in FORWARD. 4. Correct Grip 90˚ Start screwgun before applying driving pressure.
PAGE 2
PARTS - SCHEMATIC - COMPONENTS Screwgun Extension Attachment Bit Bit Release Slot Extension Mandrel inside extension G2 Locking Lever Handle Mandrel inside attachment Nose Piece Part #: PMANDREL65 (QDPRO200, QDPROLDHG2, QDPROPHG2) Depth Adjustment Wheel Guide Tube PMANDREL75 (QDPRO200SG2, QDPRO250G2, QDPRO300SG2, QDPRORFG2, QDHSD60, QDHSD75) Feed Pawl Lever (Must be engaged in Feed Pawl Assembly Slot) Bit Release Key Built in on all G2 models Non-Skid Teeth part # 150187 (QDPRO200S, QDPRO300S)
PAGE 3
OPERATING INSTRUCTIONS ATTACH ADAPTOR TO YOUR SCREWGUN (If you purchased a complete system with screwgun; skip this step) • Remove nose-cone and bit holder from your screwgun according to manufacturer’s directions (most will pull straight off). • Replace with Quik Drive adaptor made for the screwgun. Follow specific instructions included with Quik Drive adaptor. INSTALL CORRECT BIT • Be sure you have the correct bit for the screws you are driving.
PAGE 4
READ AND FOLLOW ALL INSTRUCTIONS WHEN SERVICING USE ONLY IDENTICAL QUIK DRIVE® REPLACEMENT PARTS. ATTENTION - Please see screwgun manufacturer's instructions for safe use of electric power tools. CHANGING NON-SKID TEETH On models with removable non-skid teeth, the nibs can be reversed to protect some surfaces. (1)Insert a screw in the hole at top of nosepiece and pry the nibs off. Replace by sliding onto front of nosepiece (2)and pressing against a hard surface (3a - 3b).