MSDS

ETI AND ETIG ADHESIVE - MATERIAL SAFETY DATA SHEET PAGE 5 OF 6
V. FIRE - FIGHTING MEASURE S
Suitable Extinguishing Media : Water spray, fog or foam, carbon dioxide, dry chemical, limestone powder.
Fire And Explosion Hazard: Irritating and toxic fumes may be produced at high temperature. In a fire, may produce
carbon monoxide , toxic nitrogen oxide, ammonia, and carbon dioxide . Use of water may
result in the formation of very toxic aqueous solution. Do not allow run - off from fire
fighting to enter drains or water courses.
Fire Fighting Equipment and Wear full protective clothing and self - contained breathing apparatus for fire fighting.
Procedures: Isolate fuel supply from fire. Clear fire area of all non - emergency personnel.
VI . ACCIDENTAL RELEASE MEASURES
Personal Precautions: Use cautio us judgment when cleaning up spill. Shut off leaks, if possible without
personal risk. Wear suitable protective clothing, gloves and eye/face protection.
Evacuate personnel to safe areas.
Environmental Precautions: Construct a dike to prevent spreadi ng. Keep out of sewers, storm drains, surface waters,
and soils.
Clean - up Methods: Small spills : Soak up with absorbent material such as clay, sand or other suitable non -
reactive material. Place in l eak - proof containers. Seal tightly for prope r disposal.
Large spills : Approach suspected leak areas with caution. Create a d ike or trench to
contain material. Soak up with absorbent material such as clay, sand or other suitable
non - reactive material. Place in l eak - proof containers. Seal tightly for proper disposal.
Additional Information: Notify authorities if any exposures to the general public or environment occur or are
likely to occur. Dispose in accordance with federa l, state, and local regulations.
VI I. STORAGE AND HANDLING
Storage: Keep away from: acids, oxidizers, heat, or flames. Keep in cool, dry, well - ventilated area
in closed containers. Protect containers from physical damage.
Handling: To prevent skin and eye contact under the foreseeable conditions of us e, wear
appropriate protective clothing and safety eyewear. When handling, do not eat, drink, or
smoke. Wash thoroughly after handling. Avoid breathing fumes. Handle in a well
ventilated work area.
VIII. EXPOSURE CONTROLS / PERSONAL PROTECTION
Protective Measure: Wear appropriate personal protective equipment.
Eye Protection: Avoid contact with eyes. Wear chemical splash goggles or safety glasses with side
shield.
Hand Protection: Wear chemical - resistant gloves such as: Nitrile, neopren e, butyl.
Skin and Body Protection: Wear chemical - resistant gloves and other clothing as required to minimize contact.
Respirator Protection: Not required for properly ventilated areas.
Exposure Limits:
Chemical Names
ACGIH
(TLV)
OSHA
(P EL)
N- aminoethylpiperazine N/E N/E
Nonylphenol N/E N/E
IX. PHYSICAL PROPERTIES
Appearance Specific Gravity
ETI Hardener Blue liquid 0.96 @ 72°F
ETIG Hardener Blue paste 0.99 @ 72°F
Odor: Ammonia
Vapor Pressure: Not Volatile
Boiling Point : N/E
Freezing Point: N/E
Flash Point : 24 0
o
F (Open Cup)
Solubility In Water: N/E