Installation Guide

ManualsBrandsSimply Put ManualsCabinet Organizers20.5-in W x 5.6875-in H 1-Tier Pull Out Metal Soft Close Cabinet Organizer

Double Pullout Waste Bins

Installation Instructions

Inspect all parts and read all instructions prior to beginning assembly and installation.

SP-BSC12-2-27-P

SP-BSC15-2-35-P

Place sliding base assembly on cabinet floor,

in desired position. Position front mounting

strap against the back edge of the cabinet

face frame. (If installing in a frameless cabinet,

measure 1/2" to 3/4" back from front of

cabinet opening, and align sliding base

assembly parallel to cabinet opening.) Close

door to make sure the assembly will not

hold cabinet door open. Also, check to see

if unit will clear the door opening when fully

extended. Once position is determined, fasten

in place using four mounting screws provided

and a Phillips head screwdriver.

OPTIONAL STEP: Mark placement of mounting

holes with a pencil, remove sliding base

assembly and drill pilot holes for fastening

screws. Place sliding base assembly back into

position and fasten with the provided screws.

IMPORTANT: The front and rear wire cages

are different. Install the rear cage first.

Tools Required

• Phillips Head Screwdriver

• Drill with 1/16" (1.5mm) bit for

drilling pilot holes

• Pencil

Product Assemblies

Waste Bin (2)

Wire Cage (2)

Sliding Base Assembly (1)

Handle (1)

Cage Locking Clip (2)

Mounting Screws (4)

Parts Included

Rear

Front

Mounting

Straps

Sliding Members

Summary of content (4 pages)

PAGE 1
Double Pullout Waste Bins Installation Instructions Inspect all parts and read all instructions prior to beginning assembly and installation. Tools Required • Phillips Head Screwdriver • Drill with 1/16" (1.5mm) bit for drilling pilot holes • Pencil Parts Included Waste Bin (2) Sliding Base Assembly (1) Mounting Straps Wire Cage (2) Handle (1) Product Assemblies SP-BSC12-2-27-P SP-BSC15-2-35-P 1 Place sliding base assembly on cabinet floor, in desired position.
PAGE 2
Install the rear wire cage first. Fully extend sliding members out of the cabinet. Place the slotted holes on the cage onto the tabs on the left hand sliding member. (2A) Rest the cage on top of the clip retainers on the right hand sliding member, but, DO NOT PUSH DOWN. Close unit so that the wire cage is completely inside of the cabinet. Now, push down firmly on the right side of the wire cage, until it is fully seated into the clip retainers. (2B) Repeat the same process for the front wire cage.
PAGE 3
Contenedores de basura desmontables Instrucciones de Instalación Inspeccione todas las piezas y lea todas las instrucciones antes de comenzar con el armado y la instalación. Herramientas necesarias • Destornillador Phillips •T aladro con broca de 1/16 pulgadas (1.
PAGE 4
2 Instalar primero el soporte posterior. Extender completamente los brazos deslizantes fuera del gabinete. Encajar los orificios del soporte en las pestañas del brazo deslizante de la izquierda. (2A) Colocar el soporte encima de los retenedores en el brazo deslizante de la derecha, pero sin presionar hacia abajo. Cerrar la unidad para que el soporte de alambre quede por completo dentro del gabinete.