User Manual

WEP

network = {

# WEP encryption

ssid="Bluegiga"

key_mgmt=NONE

wep_key0="ASCII WEP key"

#wep_key0=0123456789

wep_tx_keyidx=0

}

ASCII WEP key is given in quotes (e.g. "abcde" or "abcdeabcdeabc")

hex digits are given without quotes (e.g. 0123456789 or 01234567890123456789012345)

WPA/WPA2

network = {

# WPA/WPA2 encryption

ssid="Bluegiga"

scan_ssid=1

key_mgmt=WPA-PSK

psk="WPA shared key"

}

shared key length must be 8..63 characters

A reboot is needed for the new settings to take effect. From WWW Setup, you can do this at Setup - Advanced settings -

Reboot system (confirm)

The current software version does not support Wi-Fi bridging in the client (managed) mode, which means that traffic from

Wi-Fi cannot be forwarded to wired ethernet.

To debug Wi-Fi issues, you can collect and review Wi-Fi diagnostics information using application or itssetup

WWW interface at .Setup - Network settings - Wi-Fi settings - Collect Wi-Fi diagnostics

In addition, a standard set of command line wireless utilities is provided to fine-tune your Wi-Fi configuration:

iwconfig

iwlist

iwpriv

For more information on these utilities, see: http://www.hpl.hp.com/personal/Jean_Tourrilhes/Linux/Tools.html

3.3.2 Using Wi-Fi as Access Point (Master)

Please refer to document to see which USB Wi-Fi dongles support access pointTested 3rd Party Peripherals

mode. The required software packages are installed by default.

Enable Wi-Fi interface using the application or its WWW interface at setup Setup - Network settings - Enable

.Wi-Fi interface

To change Wi-Fi settings, use the application or its WWW interface at setup Setup - Network settings - Wi-Fi

.settings

To begin with, change the setting to . is used by default to manageAct as a Wi-Fi Access Point yes Hostapd

Wi-Fi access point mode.

To change settings, use the application or its WWW interface at hostapd setup Setup - Network settings Wi-Fi