Installation Guide

Acrylic Concrete & Masonry Sealer
How-To-Use
Materials:
• Safety glasses and waterproof gloves
• Gallon of Sikagard High Gloss Sealer
• Desired application tool - sprayer, brush or roller
Procedure
1. Note: A preliminary site test application is recommended (prefer-
ably on a small, prepped, inconspicuous surface) to determine
satisfactory appearance and surface slip resistance.
2. Remember to always wear waterproof gloves and safety goggles.
Insure that all surfaces are clean and sound. Remove all dust, dirt,
loose concrete, grease, curing compounds, paint and other parti-
cles by mechanical means (i.e. pressure wash, blast clean, etc.).
3. Shake product thoroughly before applying.
4. Sikagard High Gloss Sealer can be applied by sprayer, brush or
roller. Apply over the entire area moving in one direction. Addition-
al coats can be applied for higher gloss.
5. Wait one day before exposing to foot/car trafc.
Special Tips
• Substrate must be dry prior to application (minimum 48 hrs.)
• Protect from freezing
• Do not store in direct sunlight
• Do not apply if rain is in the forecast
• Concrete must be at least 14 days old
• Do not use over moving cracks
• Do not thin product
www.sikausa.com
Sikagard
®
High Gloss Sealer