Installation Guide

Sika MaxTack
®
Fast Grab Adhesive
Water-based, Interior
How-To-Use
Materials:
• Safety glasses and gloves
• Standard caulk gun
• Cartridge of Sika MaxTack Fast Grab Adhesive
• Utility knife
Procedure
1. Make sure that all surfaces are clean, structurally sound, and
dry. Remove all dirt, oil, moisture, and/or old adhesive that may
adversely affect the adhesion of the material.
2. Cut the tip of the nozzle at a 45° angle to the desired bead size,
then puncture the seal inside of the nozzle and place the cartridge
into a caulking gun.
3. Wearing protective gloves and safety goggles, hold the gun at
a 45° angle and squeeze the gun handle to start the ow of
adhesive.
4. Gun the adhesive onto the substrate/area to be bonded. A 1/8”
thickness adhesive layer must be limited to avoid sliding of the
bonded part. For heavier items, use adhesive tapes, wedges or
props to hold the assembled elements together for the rst 48
hours of curing.
5. An incorrectly positioned element can be easily readjusted during
5 minutes after application. Apply pressure again.
6. Clean up all tools, spills, and excess uncured material with clean
rags after use. If necessary, use water. Hardened/cured material
can only be removed mechanically.
www.sikausa.com