Installation Sheet

5Copper Freestanding Tub Installation Instructions
COPPER FREESTANDING TUB
7. Measure and mark each pipe so that the end of the
pipe reaches at least a little bit over halfway into the
overflow tee.
9. Apply thread sealant or plumber’s tape to the
threaded ends of all pipes prior to assembly. If two
pipes arrive attached, be sure to take them apart and
do the same. Do not apply any tape or sealant to any
compression fittings. Follow steps 10-13 for drain
assembly instructions.
6. The overflow tee (A) will be attached at the points
where the drain pipes intersect (B).
8. Remove the drain and overflow assembly from the
tub, and trim the pipes at the marked locations with a
hacksaw. Make sure that the blade is suitable for
cutting metal.
A
B