Installation Sheet

10
1.800.221.3379
3. Wrap plumber's tape on threads of shower arm.
Hand tighten shower head firmly onto shower arm.
If using a wrench, wrap shower head with towel to
prevent scratching finish.
3. Envuelva la cinta de plomero en los hilos del brazo de la
ducha. Apriete a mano el cabezal de la ducha firmemente
sobre el brazo de la ducha. Si usa una llave, envuelva la
regadera con una toalla para evitar que se raye.
5. If installing using 1/2" copper pipe, slip the spout
onto the copper pipe. Back out set screw in bottom of
spout to allow spout to slide on stub out pipe. Slide the
flange and spout over the pipe with the spout tight to
the wall, tighten the set screw to the pipe.
5. Si realiza la instalación con un tubo de cobre de 1/2“
(2.5 cm), deslice el pico en el tubo de cobre. Afloje el
tornillo de presión debajo del vertedor del grifo. Deslice la
brida y el vertedor sobre el tubo de montaje y, apoyando
el vertedor firmemente sobre la pared, vuelva aajustar el
tornillo.
4. Wrap plumber's tape around threaded end of
spout nipple. Hand tighten nipple into installed
elbow, tightening firmly. The distance from the valve
to the tub spout stub out should be between 8” (20
cm) and 18” (45 cm).
4. Envuelva la cinta del plomero alrededor del extremo
roscado del niple del surtidor. Apretar a mano el niple
en el codo instalado, apretando firmemente. La
distancia entre la válvula y la boquilla del tubo de salida
debe ser de entre 8" (20 cm) y 18" (45 cm).
KEY WEST
PRESSURE BALANCE TUB AND SHOWER SET
SET DE BAÑERA Y DUCHA DE PRESIÓN BALANCEADA KEY WEST
SKU: 948308, 948671
8"~18"
203mm~457mm
5/8"
(15.9mm)
1 1/2"~2"
(38mm~51mm)