Specification Sheet

1.800.221.3379
AIR TUB AND WHIRLPOOL TUB
PAGE 2
COMPONENTS LIST
• Powerful whirlpool pump with variable flow device
• Heated blower for air bath system
INSTALLATION
• Whirlpool and Total Massage units require dedicated
20 Amp, 120V service
• You must provide a receptacle with a 20 Amp
configuration
• Electrical outlet must be mounted 4” (101mm) above
the floor line and 12” max (305mm) inside from the edge
of the bathtub, or in accordance with local building and
electrical codes
INTEGRATED CONTROL PANEL
• Whirlpool Baths: Equipped with on/off switch actuator.
Each depression of the switch will activate the pump
• Air Baths: Equipped with a 3-speed air switch actuator.
Each depression of the switch will change the flow of air
• Total Massage Baths: Equipped with both an on/off air
switch actuator for whirlpool function and 3-speed air
switch actuator for air function
INSIDE OF BATH
• (8) HIGH-FLOW DIRECTIONAL AND VOLUME-ADJUSTABLE
WHIRLPOOL JETS
• (65) CHANNEL-FED AIRJETS (air bath and total massage)
WHIRLPOOL JET
ELECTRICAL CONFIGURATIONS
WHIRLPOOL WITH INSTALLED AIR SWITCH TOTAL MASSAGE CIRCUIT WITH OPTIONAL HEATER
AIR BATH CIRCUIT
AIR SWITCH
AIR SWITCH
AIR SWITCH
AIR SWITCH
120V, 60 HZ
20 AMP GFCI
120V, 60 HZ
20 AMP GFCI
120V, 60 HZ
20 AMP GFCI
120V, 60 HZ
9.25 AMP
PUMP / MOTOR
PIGGY BLOWER
9.5 AMP
PIGGY BLOWER
9.5 AMP
CONTROL BOX
CONTROL BOX
ON / OFF PUMP
9 AMP
HEATER
ELECTRICAL
FEED
ELECTRICAL
FEED
GFCI GFCI
ELECTRICAL
FEED
GFCI GFCI
GFCI GFCI