Installation Sheet

3
1. At your designated drain location, install the 6”
drain piece (13) into your under-floor plumbing. Slide
the escutchen (14) onto the drain piece to cover the
hole in the floor.
2. Remove the drain cover plate (4) and the overflow
cover plate (9) by twisting them out.
SWIVEL HEAD WASTE AND OVERFLOW INSTALL
Swivel Head Waste and Overflow Installation Instructions
STEP 1: FITTING AND TRIMMING
3. Remove the pop-up assembly (2) from the drain
elbow (1). Remove the rubber sealing gasket (3) from
the pop-up assembly and insert the assembly into the
drain hole.
4. Important: Do not apply any thread sealant,
plumber’s tape, or silicone yet. This will be applied
later, completing the installation.