Installation Sheet

2Freestanding Tub Faucet Installation Instructions
4. Connect the exible water feed tubes to the bottom of the faucet body. If the water feed tubes are already connected
to your faucet, move on to step 5. These are meant to be hand-tightened only. Once the tubes begin to warp as you
turn them they have been tightened enough, any further tightening could damage the connection tubes.
Tip: Each tting is marked with a sticker, blue for cold water and red for hot water. After the hoses have been
connected place a piece of masking tape on the red, or hot water hose to help ensure that the two do not get
crossed at any time during installation.
5. Thread the water feed tubes through your 1-½" hole in the oor and connect to the main water supply via the under
oor access space.
6. Briey turn on the water supply to make sure there are no leaks in the water feed tubes before you x the faucet to
the oor. If no leaks are detected, turn off the water supply and continue with the installation. If leakage does occur,
use your adjustable wrench to tighten the connections as necessary. If problems persist, contact Customer Service
at 1-866-855-2284.
7. Sit the faucet upright with the mounting plate at to the oor. Use your level to verify that the faucet is properly
aligned. If the faucet is not level place a shim underneath the mounting plate and adjust as necessary.
8. Secure the mounting plate to the oor using your drill and the appropriate mounting hardware. If there is a decorative
escutcheon, slide it down over the mounting plate and press into place.
9. If your faucet is in two pieces, nish the faucet assembly by attaching the spout, or top of the faucet. Make sure that
the 1-¼" rubber sealing gasket or O-ring is inside the top of the base so that the two pieces t tightly together without
leaking.
Tip: Once the spout is attached securely to the base of the faucet, discard the rubber O-ring that is around the
outside of the spout, this is there for shipping purposes only and is not needed after installation is complete.
10. Finish your installation by attaching any hoses and/or handles that might be included. There is a bag of extra
materials included in the packaging. There may be items that are not used at the time of installation but may be
needed later. Do not discard these materials.
Tip: If your faucet features a hand shower attachment, screw the tapered end of the hose onto the hand shower so
that the piece ts properly in the cradle.
11. Tighten the set screw located on the side of the faucet with your Allen wrench to secure the spout in place.
12. When the faucet is installed turn on the water supply, check to make sure that all connections are tight (no water
should be leaking) and that the hot and cold supplies are working correctly. If you have a hand shower, divert the
water to the hose and allow the water to ow through the hose for approximately 60 seconds.