User Manual

USER MANUAL
ZIRC
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2011 Sigma Designs, Inc.
LEARN INTO A NETWORK
Before ZIRC can be used to control a STB, it needs to be added into the STB Z-Wave network.
Step 1. Reset ZIRC to Factory Default (Refer to “RESET TO FACTORY DEFAULT”).
Remove Battery (removing battery is optional).
Step 2. Enable STB Z-Wave Add-Node (refer to STB User Manual)
(a) Insert 2 x AAA batteries into ZIRC.
ZIRC in Factory Default state will be Z-Wave Learn Mode once battery is
inserted.
OR
(b) Press any key to activate / de-activate Z-Wave Learn Mode
Step 3. Wait for indication.
GREEN Light flashes 3 times indicating Successful operation.
X 3
Flashes 3 times for Successful operation
OR
RED Light flashes 3 times indicating Fail operation.
X 3
Flashes 3 times for Fail operation
If operation fail, RESET ZIRC to Factory Default (refer to section RESET TO
FACTORY DEFAULT), and repeat Step 1 to 3 in this section.