User guide

Raven XT
14 20070914
· IfyouhavethedifferentnumbersfortheMINandMDN
orMSID:
AT*PROVISION2=MSL,MDN,MIN/MSID[,SID,NID]
Using Direct Commands to the Internal
Hardware
UseonlyiftheALEOSmethodisunsuccessful.
Activating the Modem
1. Putmodemintopassthrumodetoby‐passALEOS.This
willallowdirectcommunicationwiththewirelessmodule
forprogramming.Enteringpassthruwilltake10‐15
secondsandwillreturnan‘OK’whenitiscomplete.
AT\APASSTHRU
2. VerifyyouareinPassthrumode.
AT!STATUS
3. Unlockthemodule.
AT~NAMLCK=MSL
4. SettheMDNandMSID.
AT~NAMVAL=0,MDN,MSID,0,65535
5. Verifythesettingsarewhatyouintend edtoenter.
AT~NAMVAL?0
Note: If your carrier supports IOTA, start the IOTA session. Not all
carriers support IOTA. Please check with your carrier before you use
this command.
6. StarttheIOTAsession.
AT!IOTASTART
StatuswillbeoutputuntilIOTAcompleteswith‘IOTA
Successful’or‘1012ERROR’.
7. Resetthemodule.
AT!RESET
8. Presstheresetbuttononthefrontofthemodem.When
themodemrestarts,itshouldregisteronthenetwork.
Private Networking
Note: Please activate the modem first, before following the Private
Networking steps.