AirPrime HL7518 and AT Commands Interface Guide Rev10 0

4116303 Rev 10.0 August 10, 2017 9
AT Commands Interface Guide
3. GENERAL AT COMMANDS .............................................................................. 35
3.1. I Command: Request Identification Information .............................................................. 35
3.2. Z Command: Reset and Restore User Configuration ..................................................... 38
3.3. +CGMI Command: Request Manufacturer Identification ................................................ 39
3.4. +CGMM Command: Request Model Identification .......................................................... 39
3.5. +CGMR Command: Request Revision Identification ...................................................... 40
3.6. +CGSN Command: Request Product Serial Number Identification (IMEI) ..................... 40
3.7. +KGSN Command: Request Product Serial Number and Software Version .................. 41
3.8. +HWREV Command: Request Hardware Revision ........................................................ 42
3.9. +CSCS Command: Set TE Character Set ...................................................................... 43
3.10. +CIMI Command: Request International Mobile Subscriber Identity .............................. 43
3.11. +GMI Command: Request Manufacturer Identification ................................................... 44
3.12. +GMM Command: Request Model Identification ............................................................ 44
3.13. +GMR Command: Request Revision Identification ......................................................... 45
3.14. +GSN Command: Request Product Serial Number (IMEI) ............................................. 45
3.15. +GCAP Command: Request Complete TA Capability List ............................................. 46
3.16. +KODIS Command: Access ODIS Information ............................................................... 46
3.17. &R Command: RTS and CTS Option .............................................................................. 47
3.18. +FMI Command: Request Manufacturer Identification ................................................... 48
3.19. +FMM Command: Request Model Identification ............................................................. 48
3.20. +FMR Command: Request Revision Identification ......................................................... 49
3.21. \N Command: Data Transmission Mode ......................................................................... 49
3.22. N Command: Negotiate Handshake Option .................................................................... 50
3.23. S5 Command: Write Command Line Editing Character ................................................. 50
3.24. S6 Command: Pause before Blind Dialing ...................................................................... 51
3.25. S8 Command: Comma Dial Modifier Time ...................................................................... 51
3.26. W Command: Extended Result Code ............................................................................. 52
3.27. +KODIS Command: Access ODIS Information ............................................................... 52
4. CALL CONTROL COMMANDS ......................................................................... 54
4.1. A Command: Answer a Call ............................................................................................ 54
4.2. H Command: Hook Control ............................................................................................. 54
4.3. D Command: Dial Number .............................................................................................. 54
4.4. D> Command: Direct Dialing from Phonebook ............................................................... 55
4.5. +CHUP Command: Hang up Call .................................................................................... 55
4.6. +CR Command: Service Reporting Control .................................................................... 56
4.7. +CRC Command: Set Cellular Result Codes for Incoming Call Indication ..................... 57
4.8. +CSTA Command: Select Type of Address .................................................................... 58
4.9. +CMOD Command: Call Mode ....................................................................................... 58
4.10. +CEER Command: Extended Error Report..................................................................... 59