Technical data

Fig.8-5: Position of the slot plates and the fastening screws
8. Insert the plug-in assembly directly. Don't use force. The connections are
to be inserted in the plug on the main board.
9. Fasten the plug-in assembly with the screw used to fix the sheet.
10. Close the device door and fasten the five marked screws, see fig. 8-2
"Loosen the fastening screws at the mounting frame" on page 49.
If the card is equipped with a Plug and Play (PnP) function, it is automatically
recognized by the operating system and integrated in the system, provided that
there are no hardware conflicts (IRQ etc.) with other extension cards or con‐
nected devices.
There can be different reasons why the functions - based on the new card - are
not available after the system reboot:
● The card is not properly positioned in the PCI slot.
● The driver software of the card was not installed or was installed faulty.
● IRQ (Interrupt) conflict with other PC hardware components.
● The software of the card was not installed.
Project Planning Manual | Rexroth IndraControl VSB 40.3 Electric Drives
and Controls
| Bosch Rexroth AG 53/101
Maintenance and Installation