User Manual

ManualsBrandsSiemens ManualsFire - Addressable ModulesFDCIO181-2-EN

Building Technologies

Fire safety and security products

FDCIO181-2 Input/Output Module

Product Manual

Characteristic

l Microprocessor-controlled signal evaluation

l Automatic address setting, without encoder settings or DIP switch

l 2 monitored input, 2 monitored output

l LED display of input and output status

l Input lines monitored for open line or short/open circuit

l Prevention of noise interference through intelligent analysis of input signals

l Output lines monitored for open line or short/open circuit (when potential output not

activated)

l Output monitoring configurable(on/off)

l Control output for equipment 24 V DC, max. 2 A

l Communication with the controller via FD18-BUS(detector line)

l Directly used in dry areas. Applicable in dusty and humid areas when installed in FDCH221

housing

l “Sticker Method” easy for commissioning

Summary of content (7 pages)

PAGE 1
FDCIO181-2 Input/Output Module Product Manual Characteristic l l l l l l l l l l l l Microprocessor-controlled signal evaluation Automatic address setting, without encoder settings or DIP switch 2 monitored input, 2 monitored output LED display of input and output status Input lines monitored for open line or short/open circuit Prevention of noise interference through intelligent analysis of input signals Output lines monitored for open line or short/open circuit (when potential output not activated) Outp
PAGE 2
Application Input The status can be monitored with an input. The input can be configured by the controller or some configuration tools as follows: l l l “Status” input or “Alarm” input Lead monitoring for open line or open line and short circuit When inputting status, according to different status of contact, can be set as fallows: – Normal mode: normally open NO input – Inverted mode: normally closed NO input Fig.
PAGE 3
Configuration The following configurations are possible through the controller or configuration tool: After activating the output remains: ‒ Steady output ‒ Pulse output: How long the contact remains active can be configured by the controller or configuration tools (pulse duration). l Failsafe behavior when the FD18-BUS detector line is current-free or in degraded mode.
PAGE 4
‒ Off: Output remains in the same position as before the error ‒ Activation: Output is activated in case of an error ‒ Deactivation: Output is deactivated in case of an error The controller does not monitor external equipment status (activated/inactivated). Dry contact output Potential-free contact (Output not monitored) - Be used for controlling (e.g. closing a door). Output control is not monitored. An externally supplied 24 V DC voltage is not needed.
PAGE 5
Fig.8 Overview No.
PAGE 6
Installation Fig. 9 Fig. 10 Fig. 11 Fig. 12 Detection line connection Preparation 1. Determine type of installation: – Installing outside a switching cabinet or a control unit: use FDCH221 housing (Fig. 10). – Installing directly in a switching cabinet or a control unit: mount the module on an even surface (Fig. 9). Damage by water! In humid or wet environments always use FDCH221 housing! Procedure with installation in the housing CAUTION Overheating of the input/output module! 1. Open the housing.
PAGE 7
Dimension In: mm Specification Operating voltage Operating current (quiescent) Activation current Output - Capacity - Monitoring resistor - Diode Input - Monitoring resistor Operating temperature Storage temperature Humidity Communication protocol Load factors Connection terminals Color – Housing – Cover Protection category EN60529 / IEC529/GB4208-93 – With FDCH221 housing Approval (for Russian) 12…32 V DC 0.56 mA 0.85 mA 2 A @ 24 V DC 3.3 kΩ (1/4w) 1N5404 3.3 kΩ / 680 Ω 0...+42 °C –20...+75 °C ≤95% rel.