Condensed Operating Manual for Door Control Unit AT18 SIDOOR Condensed Operating Manual AT18 Rev. 09, Issue Date 8/2007 www.siemens.
Condensed Operating Manual for Door Control Unit AT18 1 Overview of operating elements Substructure group AT18: X1: Auxiliary module flat cable connection X3: Mains current transformer connection X4: Current output 24V / 0.
Condensed Operating Manual for Door Control Unit AT18 2 Safety instructions WARNING Only qualified personnel should work on or be in the vicinity of this equipment. This staff must be thoroughly familiarized with all warnings and maintenance procedures according to the operating manual. 3 Mechanical installation and configuration 1. 2. 3. 4. 5. Mount the motor on the motor mounting (rubber-bonded metal/vibration shock mount). Thereafter the motor is mounted on the mounting bracket if necessary.
Condensed Operating Manual for Door Control Unit AT18 12. Connect the light barrier to X6 (see illustration 1 or lid imprint). Insofar as the light barrier input is not used, X6 must be wired to X4 according to the lines on the connection layout. 13. Plug in clip plugs X6 and X4. CAREFUL The control is operative after the next switch-on. At a presented control signal the door moves into the specified direction. 14. Switch control on (plug in mains current plug, or plug X3).
Condensed Operating Manual for Door Control Unit AT18 in the bottom right corner of the display. 6. With a short pressing of the red parameter button (S5000) one can switch to parameter “A” (counterweight). The alternatively displayed numerical value represents the counterweight in kg (adjustment range 0 kg to 6 kg). It can be adjusted with the service button – “OPEN” and – “CLOSE” (S5001, or S5002). 7. The set value is saved by a long pressing of (>2s) of the parameter button (S5000). 8.
Condensed Operating Manual for Door Control Unit AT18 7 Parameter setting with terminal module or user terminal The terminal module (option) or the user terminal can equally be used for the diagnosis and setting of the parameter. The buttons of the tools have identical designations and significance.
Condensed Operating Manual for Door Control Unit AT18
Condensed Operating Manual for Door Control Unit AT18 Ýçindekiler 1 Ýçindekiler ............................................................................................................2 2 Giriþ ......................................................................................................................4 3 Güvenlik notlarý ....................................................................................................5 3.1 Genel güvenlik bilgileri ..................................
