User manual

Configuring the device
5.6 Configuring Autostart or wait time
Basic Panels 2nd Generation
52 Operating Instructions, 03/2014, A5E33293231-AA
5.6
Configuring Autostart or wait time
You specify in the "System Control/Info" dialog if the project starts immediately after
switching on the device or after a wait time.
1. Press "System Control/Info" to
open the "System Control/Info"
dialog.
The "Autostart Runtime" tab is
open.
2. Switch on the "Autostart" function.
3. Set the wait time with the selection
wheel under "Wait".
The wait time is the time in
seconds between the appearance
of the Start Center and automatic
start of the project.
Value range: 0 ... 60 s
Note
Immediate start of the project with a delay time of 0 seconds
The project starts immediately if a delay time of 0 seconds is set. It is now no longer possible
to call the Start Center after switching on the HMI device. To handle this situation, you need
to configure an operating element with the "Close project" function.