Data Sheet

ManualsBrandsSIEMENS ManualsSiemens PLCs6AG1431-0HH00-4AB0 PLC add-on module

Data sheet 6AG1431-0HH00-4AB0

SIPLUS S7-400 SM 431 16AI for medial exposure based on

6ES7431-0HH00-0AB0

Supply voltage

Load voltage L+

● Rated value (DC)

24V; Only required for supplying 2-wire transmitters

● Reverse polarity protection

Yes

Input current

from load voltage L+ (without load), max. 400mA; for 16 connected, fully controlled 2-wire transmitters

from backplane bus 5 V DC, max. 100mA

Power loss

Power loss, typ. 2W

Analog inputs

Number of analog inputs 16

● For voltage/current measurement

permissible input voltage for voltage input

(destruction limit), max.

20V; 20 V DC permanent, 75 V DC for max. 1 s (duty factor 1:20)

permissible input current for current input (destruction

limit), max.

40mA

6AG1431-0HH00-4AB0 Subject to change without notice

Page 1/

Summary of content (4 pages)

PAGE 1
Data sheet 6AG1431-0HH00-4AB0 SIPLUS S7-400 SM 431 16AI for medial exposure based on 6ES7431-0HH00-0AB0 Supply voltage Load voltage L+ ● Rated value (DC) 24 V; Only required for supplying 2-wire transmitters ● Reverse polarity protection Yes Input current from load voltage L+ (without load), max. 400 mA; for 16 connected, fully controlled 2-wire transmitters from backplane bus 5 V DC, max. 100 mA Power loss Power loss, typ.
PAGE 2
Input ranges ● Voltage Yes ● Current Yes ● Thermocouple No ● Resistance thermometer No ● Resistance No Input ranges (rated values), voltages ● 1 V to 5 V Yes ● Input resistance (1 V to 5 V) 100 kΩ ● -1 V to +1 V Yes ● Input resistance (-1 V to +1 V) 10 MΩ ● -10 V to +10 V Yes ● Input resistance (-10 V to +10 V) 100 kΩ Input ranges (rated values), currents ● -20 mA to +20 mA Yes ● Input resistance (-20 mA to +20 mA) 50 Ω ● 4 mA to 20 mA Yes ● Input resistance (4 mA to 20 mA) 50 Ω
PAGE 3
Potential separation Potential separation analog inputs ● Potential separation analog inputs No ● between the channels No Isolation Isolation tested with 500 V DC between bus and local ground Ambient conditions Ambient temperature during operation ● min. 0 °C; = Tmin ● max. 60 °C; = Tmax Ambient temperature during storage/transportation ● min. -40 °C ● max. 70 °C Altitude during operation relating to sea level ● Installation altitude above sea level, max.
PAGE 4
Remark — Note regarding classification of environmental conditions acc. to EN 60721, EN 60654-4 and ANSI/ISA-71.04 * The supplied plug covers must remain in place over the unused interfaces during operation! Conformal coating ● Coatings for printed circuit board assemblies acc. to EN 61086 Yes; Class 2 for high availability ● Protection against fouling acc.