System Manual
Table Of Contents
- SIMATIC RTLS Hardware
- Legal information - Warning notice system
- Table of contents
- 1 Introduction
- 2 Safety notices
- 3 System overview
- 4 Planning an RTLS system
- 5 Anchors
- 5.1 SIMATIC RTLS4030A
- 5.2 SIMATIC RTLS4330A
- 5.3 SIMATIC RTLS4420A
- 5.4 SIMATIC RTLS4430A
- 6 Gateways
- 6.1 SIMATIC RTLS4030G
- 6.2 SIMATIC RTLS4330G
- 6.3 SIMATIC RTLS4420G
- 6.4 SIMATIC RTLS4430G
- 7 Transponder
- 7.1 SIMATIC RTLS4030T
- 7.2 SIMATIC RTLS4060T
- 7.3 SIMATIC RTLS4083T
- 7.4 SIMATIC RTLS4084T
- 7.5 SIMATIC RTLS4460T
- 7.6 SIMATIC RTLS PCB OEM AC
- 7.7 SIMATIC RTLS PCB OEM AX
- 7.8 SIMATIC RTLS PCB OEM CHIRP
- 7.9 SIMATIC RTLS PCB OEM PULSE
Check the device for damages before you use it so that it is not damaged during operation. The
specified operating temperature ranges must be observed.
The device contains a lithium battery.
CAUTION
Fires and burns
Improper handling of batteries can lead result in fires and burns.
The housing of the device must not be squashed, punctured or exposed to other mechanical
influences. It may only be opened to change batteries.
Never expose the device to fire, temperatures above 50 °C or direct sunlight for an extended
period of time.
In dry environments the device battery must be replaced.
Assembling the transponder prior to starting up
Proceed as follows to assemble the transponder prior to starting up:
1. Insert the battery in the battery compartment according to the polarity direction.
2. Close the housing by first placing the top part into the bottom housing and letting it engage
on the bottom.
Note
Remove the batteries from the device when you are returning it.
Replacing the battery
Proceed as follows to replace the battery in the transponder:
Make sure that you observe the polarity of the batteries (marking on the battery insert).
1. Open the housing at the designated recess on the left-hand side in an upwards direction
using a suitable tool.
2. Insert the battery in the battery compartment according to the polarity direction.
3. Close the housing again until you hear it click into place.
7.1.2.2 Cleaning and maintenance
The enclosure may only be opened to change batteries.
The device may only be repaired by an authorized maintenance company or opened for other
types of work.
Improper opening or repairing of the device may result in risks for the user. Opening the device
without permission renders the warranty of the Siemens AG null and void.
Transponder
7.1 SIMATIC RTLS4030T
System Manual, 04/2019, C79000-G8976-C577-01 127