User Manual

3SU10 device range

4.2 Overview

SIRIUS ACT 3SU1 pushbuttons and signaling devices

System Manual, 02/2015, A5E03457306020A/RS-AB/002

4.2

Overview

4.2.1

Holders

The holders are used to secure the actuating or signaling elements and the contact module

or LED module. The holders are designed for mounting in front plates with a plate thickness

of 1 to 6 mm.

When delivered, the holders are set to a control panel thickness of approximately 3 mm.

They are placed in the ↑ arrow direction from the rear onto the actuating and signaling

elements. The fastening screw is located at the top. If they are to be mounted in a plate that

is > 3 mm thick, you must adjust the fastening screw of the holder before you install the

holder.

Note

Note the maximum permissible front plate thickness!

When label holders, protective caps or similar accessories are used, it is important to

remember that the maximum permissible front plate thickness must be reduced by the plate

thickness of the

relevant accessory.

Tool

For securing, we recommend a size 2 screwdriver (cross-tip DIN ISO 87641PZD1 or flat-

head DIN ISO 2380-1 A/B 1 x 4.5). The tightening torque is 1.0 to 1.2 Nm.

Grounding of the front plate

If you mount a metal actuator on a metal front plate using a metal holder, the actuator is

grounded via the tip of the fastening screw. This enables grounding via the connection on

the front plate.

①

Hole for grounding stud (accessory: 3SU1950-0KK80-0AA0)

②

Fastening screw