User's Manual

Introduction
WiN7200 Installation and Setup Guide 12
1.3 Interfaces
The unit is installed vertically, where the integrated GPS antenna is located on the top panel
(
facing the sky). All other connections, including the optional GPS external antenna connections
are located on the bottom panel.
1.3.1 Bottom Panel
The interface panel supports the antenna, power and Ethernet connections.
Figure 3. Pico BST Interface Panel
The following table provides a description of the Pico BST bottom panel connectors and ports.
Table 1. Bottom Panel Connectors
No. Connector
Name
Connector
Type
Cable Type Description Connected to
1 ANT1 N type
Female
RG 214/U RF antenna connection external antenna or
Screwed-on omni-
directional antenna
2 Console RJ45 Cat5 ETH Low level CLI for
WiNetworks technical
personnel. RS-232
Computer
3 DC + ETH RJ45 Cat5 ETH DC 1.5A + Ethernet Cat5 PoE data adaptor
4 GND 1 screw
ETSI
#10 AWG bare
copper wire
Grounding lug. #10 AWG
bare copper wire
Central earth ground,
Tower or pole chassis
5 GPS
(optional)
TNC
Female
RG-59 Base Station
Synchronization
Optional External GPS
antenna
6 ANT2 N type
Female
RG 214/U RF antenna connection external antenna or
Screwed-on omni-
directional antenna
GND