User's Manual

Shure Incorporated
23/51
•
1.
2.
During storage, check batteries every 6 months and recharge to 40% of capacity as needed
Installing the Battery Contact Cover
Install the included battery contact cover (65A15947) on the handheld transmitter to prevent light reflection in broadcast and
performance situations.
Align the cover as shown.
Slide the cover over the battery contacts until it is flush with the transmitter body.
Note: Slide the cover off before inserting the transmitter in the battery charger.
Audio
Setting Receiver Gain
The receiver gain control sets the audio signal level for the entire receiver and transmitter system. Changes to the gain settings
occur in realtime allowing for adjustments during live performances. When adjusting the gain, monitor the audio meter levels to
prevent signal overloads.
Receiver Gain Controls
The gain can be adjusted by using the gain ▲▼ buttons or by entering the AUDIO menu and using the control wheel.
Tip: To quickly adjust the gain, press and hold a gain button to enable accelerated scrolling.
Reading the Audio Meter
The audio meter displays yellow, green, and red LEDs to indicate the audio signal level. Audio peaks illuminate the LEDs for 2
seconds, while the RMS signal is displayed in realtime.