User's Manual
Table Of Contents
- Table of Contents
- SLX-D Wireless System
- IMPORTANT SAFETY INSTRUCTIONS
- WARNING
- Important Product Information
- Overview
- Set Up the Receiver
- Wearing the Bodypack Transmitter
- Hardware Interface
- Batteries and Chargers
- Sound Check and Gain Adjustment
- Sound Check and Gain Adjustment
- System Set Up
- Radio Frequency (RF) Settings
- Networking
- Firmware Updates
- Firmware Updates
- Mount the SLX-D Receiver in a Rack
- Accessories
- Specifications
- System
- RF
- RF Carrier Frequency Range
- Working Range
- RF Tuning Step Size
- Image Rejection
- RF Sensitivity
- Audio
- Latency
- Audio Frequency Response
- Audio Dynamic Range
- Total Harmonic Distortion
- System Audio Polarity
- Mic Offset Range
- Temperature Range
- Operating Temperature Range
- Storage Temperature Range
- SLXD4 / SLXD4D
- Dimensions
- Weight
- Housing
- Power Requirements
- RF Input
- Spurious Rejection
- Connector Type
- Impedance
- Phantom Power Protection
- Audio Output
- Gain Adjustment Range
- Configuration
- Impedance
- Full Scale Output
- Mic/Line Switch
- Networking
- Network Interface
- Network Addressing Capability
- Maximum Cable Length
- SLXD1
- Battery Type
- Dimensions
- Weight
- Housing
- Audio Input
- Connector
- Configuration
- Impedance
- Maximum Input Level
- Preamplifier Equivalent Input Noise (EIN)
- RF Output
- Antenna Type
- Occupied Bandwidth
- Modulation Type
- Power
- SLXD2
- Battery Type
- Dimensions
- Weight
- Housing
- Audio Input
- Configuration
- Maximum Input Level
- RF Output
- Antenna Type
- Occupied Bandwidth
- Modulation Type
- Power
- SB903
- Charge Voltage
- Charge Current
- Nominal Voltage
- Nominal Capacity
- Housing
- Charging Temperature Range
- Dimensions
- Weight
- SBC10-903
- Battery Charger
- DC Input Voltage Range
- Charge Current
- Charge Time
- Charge Voltage
- Operating Temperature Range
- Dimensions
- Weight
- Housing
- Power Supply
- Input Voltage Range
- Operating Frequency
- Maximum Input Power
- Output Voltage
- Maximum Output Power
- Operating Temperature Range
- SBC203
- Charge Current
- Charge Time
- External Power Supply
- Power Requirements
- Charging Temperature Range for Battery
- Dimensions
- Weight
- Housing
- Power Supply
- Input Voltage Range
- Operating Frequency
- Maximum Input Power
- Output Voltage
- Maximum Output Power
- Operating Temperature Range
- Receiver Output Connectors
- Transmitter Input
- Frequency Range and Transmitter Output Power
- Frequencies for European Countries
- Certifications
Shure Incorporated
21/43
•
1.
2.
3.
4.
5.
6.
7.
8.
CD players
Using the Guided Frequency Setup
Set up a new system:
Push the control knob on the receiver and select 1. Frequency Setup > 1.1 Guided Frequency Setup.
Select Initialize My System and push the control knob to continue.
Turn off all transmitters you plan to use with your system.
Select start scan.
After the scan is done, push the control knob to assign frequencies to the receiver.
Turn on the transmitter you plan to use with this receiver.
Align the infrared (IR) ports on the transmitter and receiver, and push the sync button.
Once the sync is complete, the system is ready for use.
Add a new receiver to your system: