User Manual

-10-

W1764 Power Feeder



The following is a description of the main components

shipped with the Model W1764. Lay the components out

to inventory them.

 If you can't find an item on this list, check the

mounting location on the machine or examine the pack-

aging materials carefully. Occasionally we pre-install cer-

tain components for safer shipping.

 

 Base ..........................................................1

 Arm Bracket ................................................1

 Power Feeder Unit ........................................1

 Arm ..........................................................1

 Base Mounting Template .................................1

 Elbow Clamp Assembly ...................................1

 Ball Joint Assembly ........................................1

 Hardware Bag  .................................1

—Cap Screw M10-1.5 x 25mm (Elbow Clamp) .........1

—Hex Bolt M10-1.5 x 50mm (Elbow Clamp) ...........3

—Lock Lever (Arm Bracket Clamp) .....................1

—Hex Nut M8-1.25mm (Arm Bracket Clamp) ..........1

—Flat Washer 8mm (Arm Bracket Clamp) ............1

—T-Handle and Pivot Bar (Ball Joint Assembly) .......1

—Hex Bolt M10-1.5 x 35mm (Base) .....................4

—Lock Washer 10mm (Base) .............................8

—Hex Nut M10-1.5mm (Base) ............................7



   



This machine has been carefully packaged for safe trans-

portation. If you notice the machine has been damaged

during shipping, please contact your authorized Shop Fox

dealer immediately.





 Box inventory.

 Hardware inventory.