User's Manual

First fix the screws on the base, insert the installed base into the left

side of the helmet, use the socket head cap screws Tighten the screws

with the knife, and install the main unit on the base.

If there are any problems with mounting tne bracket, you may use the

3M tape bracket.peel off the protective backing sheet of the 3M tape

and adhere the bracket onto the helmet.Pressfor15 seconds and

glue dry for 24 hours.

Tear off the rough surface of the left and right speaker Velcro on the

headset, and paste them on the left and right ears of the helmet, then

After attaching the speaker to the Velcro surface in the helmet, the

speaker with short headphone cable is installed in the left ear.

The long horn is mounted on the right ear.

Paste the microphone Velcro on the rough surface of the helmet, and

then paste the microphone on the on the Velcro.

INSTALLATION INSTRUCTIONS