User's Manual

Step 1：Make sure the Transmitter and receiver collar are
on paired.
Step 2：Please start the static stimulation function and adjust
the level to 10.
Step 3：Put the test light between two contact points and make
sure its interface is touching the contact points. Press
the static stimulation button again, if the test light is on
which means the static stimulation is on going .
Tips：The default factory settings of the communication
channel is channel .
Please follow the steps below if you want to switch to another
channel.
Step 1：Unlock the transmitter and long press the button
to select a signal channel.
❺Pairing and select the communication channel
9