User's Manual

1110
8. Public Address
Press the button programmed for "Public Address", "b" will be
displayed.Press the PTT button, the voice from the MIC of the
radio will be directly sent to the external speakers through the
interface on the back.
Press the "Public Address" button again to disable the public
address function.
9. Lone worker
If Lone worker is set to be enabled, press the button "Lone
worker" to enable the Lone Worker Mode. Start the Lone worker
timer and when the preset Lone worker time is reached, the radio
will alarm, after the alarm time, the radio will enter the Emergency
Alarm Mode.
In the Lone worker Mode, press the "Lone worker" button again
to quit the Lone worker mode.
In the Lone worker Mode, press the button programmed for
"Lone worker reset" the specific button to select lone worker
reset mode or any button (any button to select lone worker
reset mode), the Lone worker timer will reset and start timing
again.
12. Wired Clone Mode
If the wired clone function is enabled, the radio will not quit after
entering the wired clone mode. To return to normal user mode,
the user needs to restart the machine.
The operating steps go as follows:
1. Press [P1] buttons for power-on until show "C" and enter the
software or send Your own ID or background voice to your partner
or the system.
In the Emergency Alarm Mode, press the button "Emergency
Alarm Off" to quit the Emergency Alarm Mode and disable the
alarm tone or stop sending it and resume normal operation.
11. Remote kill, stun, activate and revive
If the radio received DTMF code programmed as remote stun,
the radio will enter the remote stun status, after replying
according to the setting, "u" will be displayed. The radio can only
receive signals and cannot send signals. If the radio received
DTMP code programmed as remote un-stun, the radio will quit
the remote stun status and enter normal operation.
If the radio received DTMF code programmed as remote kill, the
radio will enter the remote kill status, after replying according to
the setting, "h" will be displayed. The radio cannot send or receive
signals. If the radio received DTMP code is programmed as
revive, the radio will quit the remote kill status and enter normal
operation.
10. Emergency Alarm
Press the button programmed for "Emergency Alarm" (the time of
pressing must be longer than the de-bounce time of the emergency
alarm switch) to enter the Emergency Alarm mode. "E" will be
displayed. You can set alarm tone according to the programming