User's Manual

JW1582,JW1583 User manual
Remote sensor Mounting Instructions
The Remote Sensor comes with a table stand or can be wall mounted.
Table Stand –
Simply fold out the attached stand from the mounting bracket.
Wall Mounting –
Set a screw in the desired hanging location and mount.
Note: Keep the remote sensor out of direct sunlight and rain.
Do not mount on metal surface.
Remote Sensor Low Battery Indication
Low battery indication is available for the remote sensor. A battery life “ ”
icon will display on the remote sensor. Replace the batteries as necessary and
follow the setup procedure.
MAINTENANCE AND CARE INSTRUCTIONS
z Extreme temperatures shock or areas of unusual vibration should be
avoided to prevent damage to the units.
z Clean the units using only a soft, damp cloth to wipe. Do not use solvents,
abrasives with a dry cloth.
z Do not submerge units in water or other liquids.
z Do not submerge units to extremely sever temperatures – DO NOT
PLACE UNITS INTO OVENS, PREEZERS or MICROWAVE UNITS.
NOTE: Opening the housing (other that the battery compartment) of the
Remote Sensor or the Sound Spa Unit will invalidate your warranty. Do
not attempt to repair this unit – There are no consumer serviceable parts.
TROUBLE SHOOTING
Indoor and Outdoor temperatures do not match when placed next to each
other –
JW1582,JW1583 User manual
The sensor is manufactured to be +/- degree in accuracy under normal
conditions. So it is possible to have up to four degrees difference shown on the
separate temperature sensors (on could be “+2 degree ” and the
other“-2degree”.) Additionally, the calibration curve is different between the two
units because of the greater temperature range of the outdoor sensor. Errors
are usually noted on the extreme ends of the temperature ranges.
Sound Spa unit is not accepting remote transmissions -
The units may not be properly synchronized or the batteries may need to be
replaced. See “USING OUTDOOR TEMPERATURE ” section for detailed
instructions. With the two units next to each other, attempt synchronization.
Remember to always place the remote sensor within the effective transmission
range and away from large metal surfaces.
What is the recommended battery type?
We recommend using only alkaline batteries.
Where can I mount the remote sensor?
To get accurate readings and to prolong the life of your senor. We recommend
that you mount it out of direct sunlight and rain. Fog and mist will not affect the
sensor, but large volumes of soaking rain may. To guard against this, we
recommend that you mount it under the eve of your house, your garage or any
other suitable place that will keep it out of direct sun and rain. Modifications not
authorized by the manufacturer may void users authority to operate this device
Outdoor Temperature Reading shows “-- ”
The may indicate a low battery or out transmission range.