User's Manual

Document Name: APN0000238_V0.3.1_UDE07XX_User Manual_Elevator Control System 20220728.doc
Document Security Level: Level 2
Doc.#:
#: APN0000238_V0.3.1_UDE07XX_User Manual_Elevator Control System 20220728.doc
Page 6 of 10
This Record Storage Period: Permanent
In order to ensure normal and stable operation of the equipment and your personal and
property safety, please carefully read the following notes before installing RFID
integrated reader:
1. Please disconnect the power supply before wiring and do not operate with electricity
2. First check whether the outlet is connected to the ground, and check if the local
power supply voltage meet reader voltage requirements;
3. Check if the device is connected tightly;
4. Pay attention to the network cable and serial cable type selection and length
restrictions;
Serial port cable length 5m maximum.
RS485 length 80m maximum.
Ethernet length 80m maximum.
5. When installing multiple readers, the antenna position and the antenna spacing should
be appropriate to avoid interference with each other.
6. Please test & ensure the reader can work normally before using it.
3.1.2Horizontal Pole Installation
(1)Align the L-shaped mounting bracket against the screw poles on bottom of reader
housing, then install the rubber and screw the M6 nuts, refer to Figure 3-1.
Figure 3- 1 L-shaped mounting bracket installation