User's Manual

HT2.008.008SS
4
3.2 Volume and weight
HT-PW361-S active tamper wristband tag size is 248mmX46mmX19mm，weight is：50g。
3.3 Software interface
HT-PW361-S active tamper wristband 2.4G software interfaces conform to 《Q/HT
1006-2011 2450MHz active RFID air interface parameters V13》regulations and standards.
4 Wear and test
Before wearing HT-PW361-S wristband tag, please read this manual carefully.
4.1 Wear condition
Before wearing HT-PW361-S wristband tag, please carefully check whether the product is in
good condition. If there is a shortage of damage, please contact and replace it in time.
4.2 Select wear position
HT-PW361-S wearing mainly has the following requirements:
1) Wear on the wrist of a person with the wristband facing upward and no shield affecting the
wireless signal.；
2) Choosing appropriate wrist band hole according to wrist size；
3) Fasten the anti-disassembly buckle to ensure that it cannot be disassembled by hand.
4.3 Active wristband tag debug
HT-PW361S active wristband tag debug：125KHz activating range 和 2.4G communication range test
4.3.1 Activating range test
Our activator test is used to test the activating range of the wristband tag. The activating range test
can be carried out from near to far, or from far to near.
4.3.2 Communication range test
Our 2.4G reader test is used to test the 2.4G reading range of the wristband tag. 2.4G reading range
test can be carried out from near to far, or from far to near.
5 Use and operate
The reading operation of the wristband tag is carried out with a matching reader. The specific
operation process can be referred to the SAAT-F527 reader instruction.
6 Day-to-day maintenance