Owner's Manual

37
Replacing the operating batteries
1. Press
OFF
to turn the power off.
2. Loosen the screw and remove the battery holder cover on the back
of the unit. (Fig. 1)
3. Remove the used batteries by prying them out with a ball-point pen.
(Fig. 2)
Do not use a mechanical pencil or sharp pointed object. This may
break and cause damage to the mechanical pencil and/or the
Organizer.
4. Install two new batteries with the (+) sides facing up. (Fig. 3)
5. Replace the holder cover and secure it with the screw.
6. Press
ON
.
The display will appear after approximately 3 seconds. If nothing is
displayed, press the RESET switch on the front of the unit and press
ON
again.
7. Set the clock (refer to page 6) and adjust the display contrast (refer
to page 30).
If the batteries become weaker (the alarm or the key beep does not
sound), the power may go off during operation or the Organizer may
fail to turn on. The memory contents will still be retained by the
memory backup battery. Replace the operating batteries to avoid loss
or alteration of data.
Precautions on battery use
Always replace both operating batteries at the same time. Do not use
an old battery and a new one together. Use only the specified lithium
batteries.
Replace the memory backup battery at lease every 5 years. The
original batteries were installed in the factory at the time of shipment
and might be depleted before satisfying the operating time indicated in
the specifications.
Battery precautions
• Keep the batteries out of the reach of children.
• When batteries become weak, remove them from the Organizer
immediately. If depleted batteries are left in the Organizer for any length
of time, they might leak and cause corrosion inside the Organizer.
• Do not dispose of batteries by fire as they may explode.
Operating batteries:
Replacement intervals for the power source batteries
When “ BATT ” is displayed, the operating batteries are depleted.
Press
OFF
to turn the power off, then turn the power back on. If the
following display appears when the power is turned on, replace both
operating batteries immediately:
• Do not press
ON
until the battery
replacement procedure is com-
pleted.
< CAUTION >
OPERATING
batteries !
Replace the
BATT
(Fig. 1)
(Fig. 2) (Fig. 3)