User Guide

E-19
Setup & Connections
Power ON/OFF
Press the MAIN POWER switch on the side of the
projector. The POWER indicator lights up red and the
projector enters standby mode.
• When the main power is not on, the remote control cannot
be used to operate the projector.
Turning on the Main Power
TEMP LAMP2 LAMP1 POWER
2 1
Press POWER ON.
• The flashing green LAMP REPLACEMENT indicator
shows that the lamp is warming up. Wait until the
indicator stops flashing before operating the projector.
• If the power is turned off and then immediately turned
on again, it may take a short while before the lamp
turns on.
• After the projector is unpacked and turned on for the first
time, a slight odor may be emitted from the exhaust vent.
This odor will soon disappear with use.
When the power is on, the LAMP REPLACEMENT
indicator lights, indicating the status of the lamp.
Green: Lamp is ready.
Flashing green: Warming up.
Red: Change the lamp.
• When setting the lamp mode to “Lamp 1 only” or “Lamp
2 only”, only the LAMP REPLACEMENT indicator
corresponding to the lamp set is lit.
TEMP LAMP2 LAMP1 POWER
2 1
POWER
buttons
1.2.3 4.5.6
Conference Series
Press POWER OFF.
Press POWER OFF again while the message is
displayed.
• If you accidentally pressed POWER OFF and do not want
to turn off the power, wait until the power off screen
disappears.
• When POWER OFF is pressed twice, the POWER indicator
will light up red and the cooling fan will run for about 90
seconds. The projector will then enter standby mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing POWER
ON. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicators light green.
• The POWER indicator flashes if the front filter is not securely
installed.