Operation Manual

-68

Cleaning and Replacing the Dust Filters

4 Replace the filter cover.

• Insert the filter cover as shown in the

figure and push both the two tabs until

you hear a click.

Remove

Attach

Pierced through

the nine slits.

Insert the filter

below the six tabs

on both left and

right sides.

Note

• Be sure the filter cover is securely installed.

The power will not turn on unless it is cor-

rectly installed.

Replacing the Dust Filters

After removing the filter cover (see

step 2 of “Cleaning the Dust Filters”),

remove the dust filters, then replace

with new ones.

• Pick the dust filters up with your fingers and lift

them out of the filter cover.

• When attaching the dust filters, make sure that

these are inserted below the tabs on both left

and right, and that the slits are pierced through.

•

If the filters become too dirty to clean effec-

tively, purchase new ones (9NK3243101400)

from your nearest Sharp Authorized Projec-

tor Dealer or Service Center.

Info