PROJECTOR OPERATION MANUAL XV-Z12000

Introduction
-11
3
2
1
1
PUSH!
3
16
Remote control
sensor
13
18
Kensington Security
Standard connector
INPUT 2 terminals
Terminals for
component and RGB
signals
.
19
INPUT 5 terminal
Terminal for DVI
digital, computer
RGB and component
signals.
18
INPUT 1 terminals
Terminals for
component and
RGB signals
.
17
INPUT 3 terminal
Terminal for
connecting video
equipment with an
S-video terminal.
26
WIRED REMOTE
control input
terminal
17
INPUT 4 terminal
For connecting
video equipment.
77
Intake vent
Rubber cap
The terminal cover can be attached
after removing the rubber cap.
DC 12V OUTPUT
terminal
25
RS-232C terminal
For controlling
projector using a
computer.
AC socket
77
Exhaust vent
77
Intake vent
Projector (Rear View)
Using the Kensington Lock
This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security Sys-
tem. Refer to the information that came with the system for instructions on how to use it to secure the projector.
Using the Terminal Cover
When the projector is used on a desktop, high mounted or
ceiling mounted, attach the terminal cover (supplied) to hide
the connecting cables.
Attaching the Terminal Cover
1 Align the hook on the terminal cover with the insert hole
in the hook at the back of the projector.
2 Press the hook in the direction indicated with the arrow to
fasten the terminal cover to the projector.
3 Insert the terminal cover into the mounting groove on the
projector while pushing the tabs inside the terminal cover
to the outside with your fingers.
Removing the rubber cap attached on the pro-
jector and attach the clips.
XV_Z12000_E_US_p05_14.p65 03.9.26, 6:35 PM11