Operation Manual

37
If problems persist contact the SHARP Helpline on tel: 0990-274277
TROUBLESHOOTING
TROUBLESHOOTING
AREA PROBLEM POSSIBLE CAUSE/CURE
RECORDING
Tape is automatically
ejected when pressing
REC ( ) or TIMER
ON/OFF buttons.
The record-protection tab has been removed.
VIDEOPLUS+ does not
record desired
programme.
Broadcast does not carry VPS/PDC signal which
alters recording time.
Check VPS/PDC mode is switched to ON.
Ensure date and time are correctly set on the
VCR.
TAPE
TRANSPORT/
MECHANISM
Tape can not be
loaded.
Make sure there is no other tape in the VCR.
Make sure you are loading the tape correctly.
Rewind is not possible. Make sure the tape is not at the start.
REMOTE
CONTROL
The VCR can not be
operated by remote
control.
Remote control is too far away from the main
unit.
Point the remote control at the VCR.
Batteries are flat - replace both.
Batteries have not been inserted correctly.
VCR is positioned in strong light.
OTHER
PROBLEMS
Picture does not
change even though
CHANNEL
/ buttons are
pressed.
Make sure the VCR is not in Timer or Menu
mode.
Desired channel
position can not be
selected.
The channel position has been set to be
skipped. Cancel the SKIP mode for that
channel.
No colour or poor TV
picture on normal
viewing.
Make sure all the cables are connected
properly.
Make sure the VCR power cord is properly
plugged in.
Not possible to view
picture or playback
through RF OUT.
Make sure the RF OUTPUT has not been switched
off. (Refer to note on RF THROUGH ON/OFF in
the TUNING THE TV TO THE VCR section of the
manual.)
Desired channel has
interference.
Possible weak signal strength, the same channel
with a better signal strength may have been
tuned in on another VCR preset channel.
Example;
VCR preset 1 = BBC1 and
VCR preset 14 = BBC1
(Refer to Manually Sorting Channels section to
move the channel to your desired position.)
TV aerial may need adjusting.
No picture appears. Make sure the TV is on the video channel.
Check all connecting cables.
TINS-3881 ENGLISH.BOOK Page 37 Wednesday, June 28, 2000 2:37 PM