Operation Manual

32
If problems persist contact the SHARP Helpline on tel: [phone]
CUSTOMISED INSTALLATION
MANUALLY SETTING THE CLOCK
The clock will normally be set using teletext information during the VCR’s auto installation of
the broadcast channels. If for any reason teletext signals are not present your VCR will not be
able to set the clock. This procedure will allow you to set the clock manually.
1. Press MENU.
2. Press the [ / ] menu select buttons to
select SET UP. Press
SET to confirm.
3. Press [ / ] to select CLOCK. Press SET to
confirm.
4. Press [ / ] to select either 12 or 24 hour
clock.
5. Press [/] to select TIME. Enter the time
using the
NUMBER BUTTONS or
[ / ]. If the minutes or hours are less than
10, enter the leading 0. If using the 12 hour clock
enter AM or PM by pressing on the remote
control.
6. Press [/] to select DATE. Enter the date
using the
NUMBER BUTTONS or the
[ / ]. For example, for 1st April
enter
01 04.
7. Press [/] to select YEAR. Enter the last two
digits of the year using the
NUMBER
BUTTONS or [ / ]. For example, for
2000 enter
00. For the year 2001 enter 01.
8. Select * for AUTO CLOCK on/off
(
* is ON, - is OFF). Then press SET to confirm.
NOTE:
• If AUTO CLOCK is set to OFF (- is OFF) then you will need to update the clock for
daylight saving.
SET UP
CHANNEL PRESET
CHANNEL SORT
CLOCK
SECUR I TY CODE
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
CLOCK
MODE T I ME DATE YEAR
24H 0:00 01/04 00 *
MODE: 24H / 12H
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
MENU SET
CLEAR
DISPLAY
PLUSCODE
MODE OSD
TIMER
ON/OFF
AUDIO
OUT
SKIP
SEARCH
ZERO
BACK
231
4
7
5
8
6
9
Remote Control
Menu select buttons
➘
TINS-3881 ENGLISH.BOOK Page 32 Wednesday, June 28, 2000 2:37 PM