Operation Manual

Remote Operations
49
2. Answering
Machine
Retrieving your messages
1 Call the machine from a touch-tone telephone. When your outgoing
message begins, press on the telephone.
• You will hear a short beep, and the outgoing message will stop.
2 Enter your remote code number and then press .
• You will hear a series of beeps equal to the number of messages recorded,
or one long beep if four or more messages have been received. The
machine will then play back the messages, beeping once at the end of each
message. When all messages have been played back, you will hear a long
beep.
• If no messages have been received, you will hear a short beep. You can
either hang up, or perform any of the operations described in the following
section, Other remote operations .
3 While the messages are playing, you can do any of the following:
• Repeat: To listen to a message a second time, press and on the
telephone before that message ends. To move back to the previous
message, press and during the first 3 seconds of the current
message.
• Skip forward: To skip forward to the next message, press and
on the telephone.
• Stop: To stop playback, press and on the telephone. After this,
you can enter any of the commands described in the following section,
Other remote operations .
• Play new messages: To listen to only your new messages, first stop
playback by pressing and , and then press and .
2
2
5
0
0 6
all.book Page 49 Wednesday, November 12, 2003 9:50 AM