Operation Manual

Messages and Signals
117
9. Trouble-
shooting
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see page 88 for display
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
Check the printing paper. If the tray is empty, add
paper and then press the START/MEMORY key. If
there is paper in the tray, make sure it is inserted
correctly (take out the stack, align the edges evenly,
and then reinsert it in the tray) and then press the
START/MEMORY key.
CHANGE CARTRIDGE This message appears after you install or replace the
print cartridge (see page 19).
CHECK CARTRIDGE The print cartridge is missing and must be installed,
or is not installed correctly.
COVER OPEN The print compartment cover is open. Close it.
DOCUMENT JAMMED The original document is jammed. See the following
section,
Clearing Paper Jams . Document jams will
occur if you load more than 20 pages at once or load
documents that are too thick (see page 54). The
document may also jam if the receiving machine
doesn’t respond properly when you attempt to send a
fax.
FAX RX IN MEMORY A fax has been received in memory because the print
cartridge needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
FUNCTION MODE The FUNCTION key has been pressed.
INK NEAR EMPTY The cartridge is nearly empty (approximately one
eighth of the ink remains).
all.book Page 117 Wednesday, November 12, 2003 9:50 AM