UP-3500 Operation-Manual Second-Edition GB

200

How to Program Alphanumeric Characters

When you program alphanumeric characters, the character keyboard will be displayed as shown below.

[TEXTCOPY] : Used to copy the text data.

[PASTE] : Used to paste the text data.

[TEXT_START] : Used to skip to the start of a text.

[TEXT_END] : Used to skip to the end of a text.

[CANCEL] : Used to cancel programming and to get back to the previous screen.

[OK] : Used to finalize programming.

[NORMAL/DOUBLE] : Used to change the normal size or double size.

[INS] : Used to switch the insert/over-write mode.

[DELETE] : Used to delete the character or figure at the cursor position.

[BACK_SPACE] : Backs up the cursor for deleting the character or figure at the left of the cursor.

[ ] : Used to control the cursor (left)

[ ] : Used to control the cursor (right)

[ ] : Used to control the cursor (down)

[ ] : Used to control the cursor (up)

[SHIFT] : You can enter an upper-case letter by using this key. Touch this key just before you

enter the upper-case letter. You should touch this key each time you enter an

upper-case letter.

[LIST] : Used to change the page of characters.

[CAPS] : Used to enter the capital-letters lock mode.

[ENTER] : Used to start a new line.

▲