Operation Manual, User's Manual

5-118
SCANNER/INTERNET FAX►OTHER FUNCTIONS
STARTING A TRANSMISSION AT A SPECIFIED TIME
(TIMER TRANSMISSION)
Specify a time at which a transmission or broadcast transmission will automatically take place. Transmission begins
automatically at the specified time.
This function is helpful when you wish to perform reserved, broadcast or other transmissions during your absence or at
night or other times when telephone rates are low.
In fax mode, a timer setting can also be specified for polling reception to receive a fax when you are not present.
• When a timer transmission is set, keep the main power switch in the " " position. If the main power switch is in the " "
position at the specified time, transmission will not take place.
• When performing a timer transmission, you must scan the original into memory when you set up the transmission. It is not
possible to leave the document in the document feeder tray or on the document glass and have it scanned at the reserved
time of transmission.
• Up to 100 timer transmissions can be stored at once.
• In fax mode, this function cannot be used in direct transmission mode or when the speaker is used to dial.
• Settings selected for a timer transmission (exposure, resolution, and other functions) are automatically cleared after the
transmission is finished. (However, when the document filing function is used, the scanned original image and settings are
stored in the built-in hard drive.)
• If another transmission is in progress when the specified time arrives, the timer transmission will begin after that
transmission is finished.
• If a job scheduled for timer transmission is given priority on the job status screen, the timer will be cancelled. The
transmission will begin as soon as the job in progress is completed.
► User's Manual (Touch Panel Operation)
•
The time can be specified up to a week in advance.
• After the timer transmission settings are specified, start the transmission in the same way as other functions.
• A timer transmission can be deleted in the job status screen.
• When in fax mode, only one timer polling operation can be stored at once. To receive data from multiple destinations by
polling, specify Timer for serial polling.
1
Place the original.
When in fax mode, then after completing this procedure, proceed to Step 3.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
► AUT
OMATIC DOCUMENT FEEDER (page 1-107)
► DOCUMENT GLASS (page 1-109)
During the day, configure the
setting to transmit received
data at 20:00.
At 20:00, the transmission
begins automatically.