Installation Manual


A
B
C
D
E
F
G
H
I
J
CLEARANCES ANd dImENSIoNS
 Dimensions that are shown in Figure 1 (for 24") or Figures
4 and 5 (for 30") must be used. Given dimensions provide
minimum clearance. Locate electrical outlet in the shaded
area in the upper left-hand corner of the cutout. See Figure 9.
 Contact surface must be solid and level. Pay special attention
to the oor on which the Microwave Drawer will sit. The
oor of the opening should be constructed of plywood strong
enough to support the weight of the oven (about 100 pounds).
 Check location where the Microwave Drawer will be
installed for proper electrical supply.
 Your oven can be built into a cabinet or wall by itself or
under a gas or electric wall oven.
 Be sur
e that the clearance of the oor between the wall oven
and the microwave drawer is a minimum of 2-inches.
 The microwave interior will easily accommodate a 9" x 13"
oblong dish or a bag of microwave popcorn.
 The oven can also be mounted ush. Please see instructions
for ush mounting included with the Flush Mount Deector
vent.
24" mICRoWAvE dRAWER mEASUREmENtS
B
C
G
D
B
C
D
E
F
G
H
I
I
J
K
L
M
N
O
P
A
Q
A
F
E


Cutout Dimension 22
1
/8" x 15
9
/16"
A. 6"
B. Suggested electrical outlet location*
C. Anti-Tip block
D. 5"
E. 3-1/2"
F. 4"
G. 22-1/8" opening
H. 14-13/16" to bottom of Anti-Tip block
I. Allow 7/8" overlap
J. 23-1/2" minimum depth
K. Allow 3/16" overlap
L. 36" countertop height
M. Allow 7/16" minimum overlap
N. Floor must support 100 lb
O. 24" cabinet minimum
P. 15-9/16" opening
Q. Allow 1/8" overlap
Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer’s location.
This Microwave Drawer can be installed below any electric or
gas wall oven.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach. Power
cord access hole in cabinet should be a minimum 1
1
/2" diameter
hole and deburred of all sharp edges.
IMPORTANT
Always allow sufcient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.
A. 21-5/8"
B. 4-11/16"
C. 1-3/4"
D. 21-7/8"
E. 23-7/8"
F. 15-7/8"
G. 14-19/32"
H. 1-9/64" door thickness
I. 15" auto drawer opening
J. 4"