User's Manual

UNPACKING AND INSTALLATION INSTRUCTIONS

• Phillips Screwdriver

• Electric Drill

• 1/2”, 5/8” and 3/32” Drill Bits

• 1-1/2” Wood Bit or Metal Hole Cutter

(if metal cabinet is used)

• Saw to cut exhaust opening

(if needed)

• Protective Drop Cloth for product and

range - you may also use carton for

protection

• Scissors

• Pencil

• Measure

•Tape

Figure 4

Parts shown not to common scale.

ITEM NAME QUANTITY PART CODE

1 Wood Screw 5 X 30 mm 6* XTSSD50P35000

2 Toggle Bolt with nuts #10 - 24 X 50 mm 4** LX-BZ0195WRE0

3 Top Cabinet Screw 5 X 60 mm 2 XBRSD50P60000

4 Power Cord Hanger 1 LX-MZB001MRE0

5 Tapping Screw 4 x 12 mm 8 XOTSE40P12000

6 Flat Washer 30 mm diameter 2 XWHSD50-16300

7 Grommet 1 LBSHC0040MRE0

8 Rear Cushion 1 PCUSUB059MRP0

9 Exhaust Damper Assembly 1 FFTA-B005MRK0

! Scale Plate 2 LANG-B004MRP0

" Grease Filter 2 PFIL-B008MRE0

# Bottom Sash 1 HDEC-B001MRF0

(white model) HDEC-B005MRF0

The INSTALLATION HARDWARE items 1 - 7 are in a small bag. Items 8 - " are packed separately. All items

are in a small carton packed below the oven.

5 TOOLS RECOMMENDED FOR INSTALLATION

6 INSTALLATION HARDWARE

* Must use two - may use remaining four. **May not use all depending on stud location.

R-2110J manual#372 5/10/04, 2:44 PM8