Projector User Manual

Connecting the Projector to Other Equipment

Before connecting, ensure that the power cord of the projector is unplugged from the AC outlet

and turn off the equipment to be connected. After making all connections, turn on the projector

and then the other pieces of equipment. When connecting a computer, ensure that it is the last

equipment to be turned on after all the connections are made.

IMPORTANT:

Ensure that the appropriate input mode has been selected on the projector before

you turn on the connected equipment.

• For more details of connection and cables, refer to the operation manual of the connecting equipment.

• You may need other cables or connectors not listed below.

Terminals on the Projector

Equipment

Terminal on

connected equipment

Cable

Terminal on the

projector

Computer

RGB

output

terminal

RGB cable (supplied) COMPUTER/

COMPONENT 1,2

HDMI output

terminal

HDMI cable (commercially available) HDMI

• Depending on speciﬁcations of equipment or the DVIóHDMI digital cable, the signal transmission

may not work property. (The HDMI speciﬁcation does not support all connections to equipment that

has digital output terminal using a DVIóHDMI digital cable.)

• You can also use the COMPUTER/COMPONENT 2 terminal as the MONITOR OUT terminal. To use

this terminal as an input terminal, set “COMPUTER2 Select” to “Input” before connecting the external

equipment. (See page 52.)

• See page 67 “Compatibility Chart” for a list of computer signals compatible with the projector. Use

with computer signals other than those listed may cause some of the functions to not work.

• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest

Macintosh Dealer.

• Depending on the computer you are using, an image may not be projected unless the

computer's external output port is switched on (e.g. Press “Fn” and “F5” keys

simultaneously when using a SHARP notebook computer). Refer to the speciﬁc instructions in

your computer's operation manual to enable your computer's external output port.

Note