1-BIT DIGITAL AUDIO SYSTEM OPERATION MANUAL SD-EX200

13
SD-EX200
03/3/14
SD-EX200_sec.fm
TINSZ0523AWZZ
2
3
4
5
6
7
8
1
Preparation for Use
- System connections -
 Antenna connection
Installing the AM loop antenna:
Outdoor FM or AM antenna:
Use an outdoor FM or AM antenna if you require better reception. Consult your
dealer.
Note:
When using an outdoor AM antenna, be sure to keep the wire of the AM loop antenna
connected.
 How to close side covers
When completing the connection, close the side covers (be careful not to trap the
wires).
 Connecting the AC power cord
After checking all the connections have been made correctly, plug the AC power cord
of this unit into the AC outlet.
Note:
Unplug the AC power cord from the AC outlet if the unit will not be in use for a pro-
longed period of time.
Supplied FM antenna:
Connect the FM antenna wire to the FM 75 OHMS
jack and position the FM antenna wire in the direction
where the strongest signal can be received.
Supplied AM loop antenna:
Connect the AM loop antenna wire to the AM and
GND terminals. Position the AM loop antenna for op-
timum reception. Place the AM loop antenna on a
shelf, etc., or attach it to a stand or a wall with screws
(not supplied).
Note:
Placing the antenna on the unit or near the AC power
cord may cause noise pickup. Place the antenna
away from the unit for better reception.
< Assembling > < Attaching to the wall >
Black
White
Wall
Screws (not supplied)
Outdoor AM antenna
49 feet (15 m)
25 feet 
(7.5 m)
Outdoor FM antenna
Ground wire
Ground rod
75 ohm coaxial
cable
Speaker wire
FM antenna wire
AM loop antenna wire
AC power cord
AC outlet
(AC 120V, 60 Hz)