Operation Manual, User's Manual

1-34
BEFORE USING THE MACHINE►BEFORE USING THE MACHINE
MOTION SENSOR
(MX-M3071/MX-M3571/MX-M4071/MX-M5071/MX-M6071 only)
This sensor detects the presence of a person that approaches the machine, and automatically wakes the machine from
sleep mode (Motion Sensor Mode Only).
Three settings are available for the detection range ( / / ).
You can warn with notification message when the motion sensor responds while the machine's power is set to OFF in
the power ON/OFF schedule settings. By setting an e-mail address for the alert destination, you can have detection
information which informs the response of the motion sensor.
• The motion sensor detects the movement of sources of heat.
• The detection range may vary depending on the installation site and environment (ambient temperature, etc.).
The motion sensor may not operate correctly in the conditions below.
• An object is in front of the motion sensor
• There are scratches or dirt on the motion sensor cover
• The motion sensor is directly exposed to sunlight or air flow
• The motion sensor is damaged
• There is a source of heat such as a heater nearby
• An object is moving in the detection range
• To enable the motion sensor
"Settings (administrator)" select [System Settings] → [Energy Save] → [Eco Setting] → [Sleep Mode Power Level].
• To issue a voice alert when the motion sensor detects movement
Select the [Send a Voice Alert when the motion sensor detects movement] checkbox in "Settings (administrator)" -
[System Settings] → [Energy Save] → [Power ON/OFF Schedule Setting].
Motion sensor
Near Far
Detection range
Approx.
maximum
1.5 m
60 degrees