Operation Manual, User's Manual

4-26
FACSIMILE►BASIC TRANSMISSION METHODS
AUTOMATIC REDUCTION OF THE TRANSMITTED
IMAGE
If the width of the transmitted image is larger than the width of the paper in the receiving machine, the image will be
automatically reduced to fit the receiving machine's paper width.
TRANSMITTABLE ORIGINAL SIZES
The following original sizes can be transmitted.
*
A long original can be transmitted.
THE SIZE OF THE ORIGINAL PLACED IN THE
AUTOMATIC DOCUMENT FEEDER
When a standard size original is placed in the automatic document feeder, the original size is automatically detected and
displayed in "Scan Size" on the base screen.
► AUTO DETECTION (page 4-45)
Standard sizes are sizes that the machine can automatically detect. The standard sizes are set in "Original Size
Detector Setting" in setting mode.
List of original size detector settings
► Detectable original sizes (page 1-105)
Transmitted image
width
Receiving machine's
paper width
Reduced size Scaling
A3 (11" x 17") B4 B4 1:0.8
A3 (11" x 17") A4 (8-1/2" x 11") A4R 1:0.7
B4 A4 (8-1/2" x 11") A4R 1:0.8
To cancel the Auto Reduction Sending setting:
In "Settings", select [System Settings] → [Image Send Settings] → [Fax Settings] → [Send Settings] → [Auto Reduction
Sending Setting].
If this setting is disabled, the image will be sent at full size and part of the image may be cut off.
Minimum original size Maximum original size
Using the automatic document feeder
131 mm (height) x 140 mm (width)
(5-1/8" (height) x 5-1/2" (width))
297 mm (height) x 1000 mm (width)
(11-5/8" (height) x 39-3/8" (width))*
Using the document glass -
297 mm (height) x 432 mm (width)
(11-5/8" (height) x 17" (width))
When the automatic original detection function is operating and the original (of inch or non-standard size) is placed, the
closest size may be displayed or the original size may not appear. In this event, manually set the correct original size.
►
SPECIFYING THE ORIGINAL SCAN SIZE IN PAPER SIZE (page 4-46)
► SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 4-47)
To specify the size that the machine can automatically detect:
In "Settings (administrator)", select the group of detected original sizes in [System Settings] → [Common Settings] → [Device
Control] → [Condition Settings] → [Original Size Detector Setting].