Specifications

Setup
ProtoMat 95s/II 29
5.3.2 Functions in BoardMaster
5.3.2.1 The Tool Magazine I/O Status dialogue box
› Click on
CONFIGURATION
,
STATUS
in the
BoardMaster
menu bar
to open the
TOOL BOX I/O STATUS
dialogue box.
fig. 16: The Tool Box I/O Status
dialogue box
The
Tool Box I/O Status
dialogue box provides information on the
signals set and the data lines connected.
•
IN
is used to check the additional lines connected to the
automatic tool change
•
OUT
indicates which lines have been activated by
BoardMaster
.
• The
REFRESH BUTTON
can be used to check whether any
status changes made have been detected and accepted by the
system.
5.3.2.2 The Tool Box dialogue box
You can call up the
TOOL MAGAZINE
dialogue box by clicking on
CONFIGURATION, TOOL BOX...
. Here you can perform a manual
check on the positions preset by LPKF for the automatic tool change.
The operator does not normally need to make any changes here as
doing so would have no effect on milling and drilling. The numerical
values entered here indicate a sample configuration.