User Manual

4
3-Prong Plug
Grounded
Receptacle Box
Grounding
Adaptor
Grounded
Receplacle Box
Grounding Pin
3-Prong Receptacle
Tab for
Grounding Screw
Screw
Permanent and Correct Installation
Temporar
y
Use
GROUNDING INSTRUCTIONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding
plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the
National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current.
WARNING – Improper use of the grounding plug can result
in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp.
or more protected electrical supply. It is recommended that a
separate circuit serving only the microwave oven be provided.
The oven is equipped with a 3-prong grounding plug. It must be
plugged into a wall receptacle that is properly installed and grounded.
Should you only have a 2-prong outlet, have a qualified electrician
install a correct wall receptacle.
A 3-prong adapter may be purchased and used temporarily if local
codes allow. Follow package directions.
A short power-supply cord is provided to reduce risk of becoming
entangled in or tripping over a longer cord.
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot
receptacle that will accept the plug on the microwave oven. The
marked rating of the extension cord should be AC 115-120 volt, 15
amp. or more.
Be careful not to drape the cord over the countertop or table where
it can be pulled on by children or tripped over accidentally.
Note:
1. If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or service person.
2. Neither Sharp nor the dealer can accept any liability for damage
to the oven or personal injury resulting from failure to observe
the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven
to your radio or TV, check that the microwave oven is on a different
electrical circuit, relocate the radio or TV as far away from the oven
as feasible or check position and signal of receiving antenna.