Owner`s manual

Service Mode
10-4 5975938 BARCOREALITY 9200TCR+ 020798
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE ...
CHANGE PROJ. ADDRESS
Enter new address
001
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return
Change Projector Address
Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change that address, push the control disc up or down to highlight
Change Proj. Address and press ENTER. The Change Projector
Address menu will be displayed and the actual address will be filled
in. The first digit is highlighted. Enter the new projector address with
:
- the digit keys on the RCU or the local keypad or
- use the control disc to the right or to the left to select a digit and
change the value by pushing the control disc up or down until the new
value is reached. Continue with the other digits on the same way.
Change Baudrate PC
The communication speed between projector and computer, e.g. PC
or MAC, has 8 possible speeds. The baud rate speed can be
software set.
Highlight Change Baud rate PC by pushing the control disc up or down
and press ENTER to display the Change Baudrate PC menu.
The following baud rates are available :
9600/4800/2400/1200/600/300/150/75
The actual baud rate will be highlighted. To change the baud rate,
push the control disc up or down and press ENTER to accept the new
baud rate setting.
Reset Lamp Runtime
Reset lamp run time is only allowed when a new lamp is installed.
Highlight Reset Lamp Run Time by pushing the control disc up or down
and press ENTER to select.
When Reset Lamp Run Time is selected in the Service Mode selection
menu, the following warning will be displayed :
Risk of electrical shock. Reset lamp run time is reserved to qualified
service personnel.
If you are not qualified, press EXIT to cancel the reset operation.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE : NORMAL
MORE...
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE
WARNING
-----------------------------------------------------
RISK OF
ELECTRICAL SHOCK
______________________________________________________________
RESET LAMP RUN TIME
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return.
CHANGE LANGUAGE
English
Français
Chinese
Change Language
Highlight Language by pushing the control disc up or down and press
ENTER to select the Language Selection menu.
Available languages : English, French and Chinese